Gammill Parts - Electrical

This cable is for a 2 wire motor. This will reverse the motor during a maintenance to help send the oil to places it will normally miss in the regu...

Fan for the inside of a Gammill Controller.

Size M TOWA Bobbin Case for all Gammill Quilting Machines and other longarms that use Size M or the Large bobbins. Premium High Quality bobbin case...

Power Supply for your Gammill MOD 3, MOD A, D & E Controller. Power Supply is modified to plug and play for the controller, no adaption needed.

Antec Power Supply for MOD F Controller Only! Power Supply is modified to plug and play for the controller, no adaption needed.

Power Supply is modified to plug and play for the controller, no adaption needed.  

Switch Connectors to be used to attach the wiring of the switches. Also known as on/off handle switch clips.  Used with the regulated machines for ...

Y Encoder Cable (Crosstrack) for Gammill Vision 1.0 & 2.0 Machines

Vertical Channel Lock Cable for Gammill Vision 1.0 & 2.0 Machines

If you are currently using a VGA cable for your monitor on your Statler and you are upgrading to a new Windows 10 Gammill computer you will need a ...

10ft 16 Gauge Extension Cord

Handle Bar Light for Gammill machines. This is not an LED light.

This curly cord/cable (similar to telephone cord) is used with the vertical and horizontal encoders. This cord / cable plugs into the back of the P...

X Encoder Cable (Crosstrack) for Gammill Vision 1.0 & 2.0 Machines.

5 Amp fuse. Used in all machines before The VISION by Gammill. If you have a Plus and Minus (or non-regulated). This is the fuse you need. All Visi...

2 pack of 6 amp fuse, to be used in all Vision by Gammill machines.If you have a machine that was before the Vision model (ie Plus, Minus) you will...

If your machine error is "no response from encoder node" or "no response from sensor node" you will need to replace this board.   The sensor board ...